Hot Oil System for Laminate Door Manufacturer
Thermal Products and Heatec were asked to design a hot oil system or thermal oil heating system to heat molds and presses for an update New York door manufacturer. The requirements from the customer included a 1.75 million btu/hr heat load with a oil flow rate range of 140 gpm to 175 gpm with an thermal oil outlet temperature of 347F. The Heatec design included ASME Code Section VIII.
The Heatec HCS-175 thermal oil heater included the following equipment on the package offered:
- HCS 175 Thermal oil heater
- Power Flame burner
- Combustion Blower
- Control Panel
- Gas Train
- Oil Train
- Hot Oil Expansion tank
- SIHI Simplex pump package
Thermal Products/Heatec can design your hot oil needs that is specific to your particular design needs. Varying oil flowrates, operating pressures, operating oil temperatures and turn downs can be accommodated, in most cases.
Contact your Thermal Products office today to discuss your project.
