Print this page

When Cooling Tower Basins Freeze

Wednesday, 13 April 2016
Rate this item
(0 votes)

In northern climates “shut-downs” can wreak havoc on your process when cooling tower basins freeze and upon “start-up”, cannot flow water to cool your process.

Thermal Products offers Indeeco’s pre-engineered, UL Listed/CSA Approved package for freeze protecting cooling tower basins.

Heaters are pre-set at the factory with a set point of 45F and will fit all tower manufactures below.

The Advantages of the Indeeco Cooling Tower Basin Heater package are as follows:

Solid-State Control

Outmoded bulb and capillary control has been replaced with new patented solid-state technology which combines temperature control with low water level protection in a single solid-state device.
NEMA 4X Enclosure
Most controls are factory wired inside a rugged NEMA 4X enclosure designed for wet, outdoor use. Pre-engineered designs up to 96 amps are available with stock and built-to-order listings, two circuit panels use a NEMA 4 enclosure.

Lower Cost

Installation time and cost are reduced by replacing individually mounted temperature and liquid level control devices with one pre-engineered and assembled control package that requires only one probe to sense both water temperature and level.

Sensor Probe Specifications :

Sensor Probe : INDEECO probe assembly incorporating both temperature and liquid level sensors.
Probe is made out of 316 stainless steel to minimize corrosion. Probe can be installed vertically or horizontally.
Maximum Pressure Rating for Sensor Probe : 15 psi
Cord : 12-foot outdoor rated cord with PVC hub connector for installation through tower basin wall. Options include different cord lengths or cord suitable for total immersion.

If you do not know your specific heater and control panel part number, then contact us with your cooling tower model number and water depth for a quote and information.

5637 times Thursday, 14 April 2016 13:46
Kevin Sommerville – President/Sales

Kevin earned a B.S. in Finance from the State University of New York.  Kevin began his career with Thermal Products, Inc while studying for his undergraduate degree.  Now in his 21st year, Kevin handles the Direct accounts and the NY, NJ, PA trade areas for Thermal Products, Inc.  In addition, Kevin brings focus to the sales and operational side of the business.  Kevin’s role is to achieve  yearly company goals through high levels of customer service, engineering design, and marketing through varying media outlets.

Mobile: 518-366-0771

Login to post comments