In northern climates “shut-downs” can wreak havoc on your process when cooling tower basins freeze and upon “start-up”, cannot flow water to cool your process.
Thermal Products offers Indeeco’s pre-engineered, UL Listed/CSA Approved package for freeze protecting cooling tower basins.
Heaters are pre-set at the factory with a set point of 45F and will fit all tower manufactures below.
The Advantages of the Indeeco Cooling Tower Basin Heater package are as follows:
Outmoded bulb and capillary control has been replaced with new patented solid-state technology which combines temperature control with low water level protection in a single solid-state device.
NEMA 4X Enclosure Most controls are factory wired inside a rugged NEMA 4X enclosure designed for wet, outdoor use. Pre-engineered designs up to 96 amps are available with stock and built-to-order listings, two circuit panels use a NEMA 4 enclosure.
Installation time and cost are reduced by replacing individually mounted temperature and liquid level control devices with one pre-engineered and assembled control package that requires only one probe to sense both water temperature and level.
Sensor Probe Specifications :
Sensor Probe : INDEECO probe assembly incorporating both temperature and liquid level sensors.
Probe is made out of 316 stainless steel to minimize corrosion. Probe can be installed vertically or horizontally.
Maximum Pressure Rating for Sensor Probe : 15 psi
Cord : 12-foot outdoor rated cord with PVC hub connector for installation through tower basin wall. Options include different cord lengths or cord suitable for total immersion.